|
|
|

TECHNOLOGY > Ultra
Filtration
|
The
DTF Module System for Ultra Filtration
|
Ultrafiltration
and Microfiltration are based on porous membranes.
Particles larger than the pore size of the membranes
are rejected. In practice
even smaller particles are rejected because of the
selectivity of the filter cake (gel layer) on the
membrane surface. A gel layer can not be avoided
in dead-end operation and is observed in most cross
flow applications. Ultrafiltration membranes form
an absolute barrier for bacteria and viruses
ROCHEM-FM
modules (Flat-Membrane) have been developed especially
for the separation of bacteria, viruses and fine
solids from water and wastewater with a high fouling
potential. Most Important the modules exhibit low
specific energy consumption at high and steady-state.
Unique is the possibility of an optimal adaptation
of the free path feed side cushions) to the individual
case. This feature allows the application in a wide
range of solid concentrations,
The patented concept of a membrane cushion stack
with completely open feed channels ( no spacers
or support
plates) in combination with the straight-through
feed flow combines the advantages of common tube
and plate/frame systems. The vertical placement
of the modules in combination with a feed side air/water
flushing allows membrane cleaning and a stable operation
for long periods without use of chemical cleaning
agents.
In addition the wide spectrum of commercially available
flat sheet membranes for Ultra-filtration (UF),
microfiltration (MF) and nanofiltration (NF) allows
the optimal selection of a membrane for each individual
application.
|
|
| |
 |
|
|
|